GN41 - Blue screen at startup/ windows will load after save and exit

[bryce]

Every time I restart the machine it goes to this recovery screen.
When is save and exit Windows loads just fine.
Any suggestions on what I can do to repair this issue.

 

[Wen]

1. Please press " F3 " load defaults and "yes" to Save
2. please try to power off, unplug the DC adapter and press the reset hole for 30 seconds

 

[bryce]

I followed all of these steps a couple times with no success.
Any other suggestions?

 

[Wen]

Please use the "win + r" ， input command "msinfo32", then tell me BIOS version, thank you

 

[bryce]

GB3V34, 07/13/2018

 

[MinisForum]

I have sent the BIOS to your email. Please flash the BIOS again.

 

[bryce]

I ran the executable file and everything seemed fine until it went to reboot.
The system never came back up at all, not even the bios page.

 

[arobatik]

Hello! Same problem, can't setup windows on emmc 64gb, when install ssd all work, bios blocked no additional settings as other version this pc. Can you give bios firmware?

 

[arobatik]

when try diskpart, no emmc memory

 

[joey]

It may be that the onboard EMMC is damaged. Please contact your sales during the warranty period.

 

[aqua]

Hi , I can't setup windows on emmc 64gb, when install ssd all work, bios blocked no additional settings as other version this pc. i really in need of the bios firmware. Please tell me where can i got it, thankyou

 

[joey]

Hi , I can't setup windows on emmc 64gb, when install ssd all work, bios blocked no additional settings as other version this pc. i really in need of the bios firmware. Please tell me where can i got it, thankyou

There is no new bios update for the N4100.