I bought this device specifically for the purpose of creating a sophos UTM. The sophos UTM runs on an isolinux variant. I have attempted to boot the installer CD with no success. I tried thumb drive as well. The installers work on any other PC but not this one. I am using the latest V10 bios and I am properly setting my boot order. It seems to be a problem with this BIOS not understanding the CD since the CD works on any other device.
Does not boot isolinux cd
- Thread starter eric d
- Start date
I thought this PCs bios was supposed to support legacy. Literally any other PC I try this on, it boots fine. I think it's this PCs bios that's lacking.
as the @spikerguy said, you can try the way
spikerguy
Member
Yes you're right there is 9.7 while Firewall version is V18.
I think you can follow op on sophos forum as you might get the answer faster on their forum.
Below are some links I could find for something similar
https://community.sophos.com/products/xg-firewall/f/initial-setup/120175/uefi-boot-xg-firewall-18-0-ga-build379
Here users asking them to release V18 with uefi support, I am not sure if they have added it or not.
https://ideas.sophos.com/forums/330219-xg-firewall/suggestions/34090690-uefi-boot
You should follow these links to get the right answer from sophos team.
Good Luck.
But like I said, your bios is SUPPOSED to do legacy support. This means it should be able to boot legacy CDs like any other computer I have does.
I don't disagree with you. But if you're not going to support legacy, why make it an option in the bios?